With a p-port rotor housing you will gain 50 HP.
Jeff Doddridge does these at low cost in his NC mill.
If you want to do it yourself try this trick.
Most hole saw do a really bad job. The problem
is not the hole saw it self. It is the mandrill and pilot that they
sell you with it. Many holes saw's have a 5/8 18 threaded
hole in the back bulkhead. I use a 5/8 18 bolt and chuck it in
the lathe to check the run out. If the bolt runs out I turn it down
to make the shaft perfectly concentric with the hole saw itself.
Otherwise I simply put the threaded portion of the bolt in a 5/8
collet.
I am also building a turbo intake manifold/inter-cooler combination for Mike
Collier's 450 HP powered Long EZ. The welder I hired to do it flaked out.
Rigidity is the name of the game when machining anything.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.