Subject: P-port 2 inch hole in rotor housing
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 1/31/2015, 4:39 PM
To: AA-1-Me


With a p-port rotor housing you will gain 50 HP.

Jeff  Doddridge does  these at low cost in his NC mill.

If you want to do it yourself try this trick. Most hole saw do a
really bad job. The problem is not the hole saw it self. It is the
mandrill and pilot that they sell you with it. Many holes saw's have
 a 5/8 18 threaded hole in the back bulkhead. I use a 5/8 18 bolt and
 chuck it in the lathe to check the run out. If the bolt runs out I
turn it down to make the shaft perfectly concentric with the hole saw
itself.

Otherwise I simply put  the threaded portion of the bolt in a 5/8
collet.

I am also building a turbo intake manifold/inter-cooler combination
for Mike Collier's 450 HP powered Long EZ. The welder I hired to do
it flaked out.

Rigidity is the name of the game when machining anything.

Paul Lamar



Is Jeff still doing this? Sent a few emails and haven't heard back.
Looking for p-port and psru adapter plate. -Matt  Boiteau



I suspect he is over loaded.

Try Randy Kempf Matt.

Randy Kempf <naa73x@gmail.com

Randy, I'll send the IGES files later today.

Randy is in Colorado Matt

Paul Lamar



Paul

I may have replied, maybe not, but I get some inquires. I try to
respond. Not really geared as a business to be immediately available,
one man band and all... Not intensional...I need about 6 units to make
this feasible, so far nobody committed....Tyin to get some guys together
to put a full order together but so far nothing lining up....still here..

Jeff




The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.