Subject: P-port 2 inch hole in rotor housing
From: AA-rotary-engine
Date: 1/31/2015, 6:18 AM
To: AAA-rotaryengine



With a p-port rotor housing you will gain 50 HP.

Jeff  Doddridge does  these at low cost in his NC mill.

If you want to do it yourself try this trick. Most hole saw do a
really bad job. The problem is not the hole saw it self. It is the
mandrill and pilot that they sell you with it. Many holes saw's have
a 5/8 18 threaded hole in the back bulkhead. I use a 5/8 18 bolt and
chuck it in the lathe to check the run out. If the bolt runs out I
turn it down to make the shaft perfectly concentric with the hole saw
itself.

Otherwise I simply put  the threaded portion of the bolt in a 5/8
collet.

I am also building a turbo intake manifold/inter-cooler combination
for Mike Collier's 450 HP powered Long EZ. The welder I hired to do
it flaked out.

Rigidity is the name of the game when machining anything.

Paul Lamar



Is Jeff still doing this? Sent a few emails and haven't heard back. Looking
for p-port and psru adapter plate.
-Matt  Boiteau



I suspect he is over loaded.

Try Randy Kempf Matt.

Randy Kempf <naa73x@gmail.com

Randy, I'll send the IGES files later today.

Randy is in Colorado Matt

Paul Lamar

 The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Copyright 1998-2015 All world wide rights
reserved.