Subject: Adding two cycle oil to my RX8
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 2/2/2015, 10:47 AM
To: AA-1-Me


I have a 2004 RX8 and Mazda put just 2 oil injectors per rotor. They
also cut back too far on the volume of oil injected and pay'ed the
price of some engine' apex seals failing. Later RX8 had 3 injectors
per rotor. BTW the main function of the apex seal oil is to cool the
seal believe it or not.

So I mix 1/4 oz of two cycle oil with each gallon of fuel. Two cycle
oil burns with out residue of any kind so it does not register on the
California smog test.

I carry a glass vinegar bottle (as in oil and vinegar salad
dressing) full of 2 cycle oil bought at Walmart by the gallon. Fits
in the door side pocket.

Each 2 inches is about 4 ounces so when I fill up (14 gallons) I dump
in 2 inches.


Paul Lamar


Hi!: you may find the two attached documents of some interest, but
I guess I've send previously the one about reduced housing wear with
leaded gasolines, that may suggest adding a bit oil in the gasoline as
you've done, or using a solid lubricant as Molybdenum, is safer, however,
not all lubricating oils are compatible with Molybdenum additives, as stated
in the SAE paper 2014-32-0115, by Husqvarna people, about a coating
for pistons that reduces mechanical losses and wear when applied to a
70 cc chainsaw engine. Single grade 2-Stroke oil is better in air cooled
Wankle RCEs, initially they got best results with Shell Rotella 30,
air-cooled engines operate at a different temp range than liquid
cooled engines, for the Comotor engines in the Citroen GS and NSU Ro 80,
they advised a mineral multi grade oil, to reduce cold start wear.
Citroen used: Total 20 W 50, it seems that mineral oils do better and
produce less ashes and gums than synthetic counterparts.

  Early work by Curtiss-Wright pointed that iron housings with an iron
rotor, that operate at higher temperatures, do reduce both HC emissions
and SFC, none is available for Mazdas, as far as I know, and it has the
difficulty of higher operating temperature meaning harder conditions
for lubricating oils, the SAE paper 2014-01-2160, by Wei Wu et al, from
the Florida University, obtained an enormous top temperature reduction
in an UEL air-cooled UAV engine, from 231º C to 129 º C, and an
almost 100% uniform temperature distribution along all housings, central
and lateral, top difference was initially 159º C, and with the heat pipe 18ª C,
improving fuel economy, power, engine life and emissions, by eliminating
thermal dilatation differences that increase mechanical losses and rub.
  Thanks for your attention, have a nice season. Best regards. Salut †
  Jose Gros-Aymerich
  Madrid, Spain



Mazda tech is way beyond Comotor, NSU and Audi. They built and sold 2 million rotary
engines capable of well over 300,000 miles running on unleaded fuel.

The stupid wacko environmentalist at the CARB
and EPA tried to justify their fat pay-checks by implementing draconian smog rules
way beyond common sense. That forced Mazda to cut back on the oil supply
to the apex seals in the 2004 RX8. They did not want to put a separate tank in
there for 2 cycle oil because they thought they inconvenience their customers.


Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.