Randy, This is what the ignition control computer covers look like.
It will be a few weeks before I am ready to order a batch.
I made enough on my cheap Chinese mill to fill my
immediate needs.

BTW I had to over haul the spindle. I was getting a lot of
chatter.  Fortunately it had tapered roller bearings. If it
had been a Bridge Port it would of cost me $2000 for matched
dual ball bearings top and bottom :) I only paid about $600
for the CCM about  45 years ago :)

There were hair line cracks in the outer race. I did not
want to just tighten it up as the bearing would totally
fail soon for sure.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.