Subject: Fwd: Re: Single rotor turbo
From: paul
Date: 2/8/2015, 2:09 AM
To: AAA-rotaryengine




Thanks for the input guys.
Your comments have been taken on board. This is the first aircraft that I have built; it is a pioneer 300 microlight or to be precise a champion V by Giuseppe Vidor, scratch built. We are limited in the microlight class in New Zealand to 600kg or 1320lbs all up takeoff weight. I am building a single rotor 13b power plant, and using the Racing Beat side plates, the turbo and fuel injection on a side port seems the best way to go.
Andrew Campbell


How much horsepower do you expect from the single rotor, FI, turbo combination?

Joe Spelz


150 HP would be easy.


The neat think about it is the turbo can be bolted directly to the
rotor housing.


Paul Lamar



   Andrew, do you have any weights of the whole package. Were you able to buy a eccentric shaft, or did you re-machine a 2 rotor one ?

   Thanks, Steve Carlisle


If you were to use a two rotor engine the turbocharger is readily available for automotive use. When using a single rotor ,
the displacement to use for the engine is what Mazda says the two rotor displacement is that your rotor and housings came from. The turbocharger manufacturer or the dealer will determine the size from that. Remember though that the A/R for the turbine housing needs to be larger than that for the same engine used for a car. Using a waste gate set for say 2PSI would work well to maintain power as you climb. Not a lot of HP increase on the ground over the basic engine but would give great cruise performance.

Dale Davies


 The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.