Subject: Fwd: Re: Single rotor turbo
From: paul
Date: 2/8/2015, 8:13 PM
To: AAA-rotaryengine


Thanks for the input guys. Your comments have been taken on board.
This is the first aircraft that I have built; it is a pioneer 300
microlight or to be precise a champion V by Giuseppe Vidor, scratch
built. We are limited in the microlight class in New Zealand to 600kg
or 1320lbs all up takeoff weight. I am building a single rotor 13b
power plant, and using the Racing Beat side plates, the turbo and
fuel injection on a side port seems the best way to go. Andrew
Campbell


How much horsepower do you expect from the single rotor, FI, turbo
combination?

Joe Spelz


150 HP would be easy.


The neat think about it is the turbo can be bolted directly to the
rotor housing.


Paul Lamar


I am going to mount my turbo behind the engine between the engine and
the firewall like a Piper Seneca. If you would go from the 2" rotor
output to a Y then to a 3" section of pipe then directly into the
turbo inlet you would accomplish 2 important things- the increase in
interior volume of the 3" pipe will allow a reduction in pressure and
velocity. The pressure reduction will force a substantial amount of
cooling to occur and the decrease in velocity will reduce the exhaust
noise. The problem with the rotary turbos has been the excessive heat
involved from continuous high HP operation. Moving the turbo
downstream a bit will help with this.

I don't know of any certified turbo airplane that has the turbos that
close to the engine. The Corvalis TT has then 18 inches away from the
cylinders and back toward the firewall and has one smaller one on
each side. The Seneca II has one in the center behind the engine fed
from both sides and dumped overboard with a single pipe.

There is a known problem with exhaust temp and velocity with these
engines, and this is one way to address it.

KA

All true but you lose overall kinetic energy.

The 280 HP third gen RX7 and the 350 HP 20B 3 rotor had the turbo's
right up against the rotor housings. There is a SS heat shield
between the turbine housing and the rotor housings.

On an horizontal opposed air cooled aircraft engine the cylinders and
the exhaust ports are so far apart it is difficult to design a smooth
exhaust manifold for a turbo anywhere near the cylinders. Even dual
turbo's.

Paul Lamar

Owing to the fact that I am only looking for 120 Hp the heat issue
should be somewhat less than for a twin or tri rotor. Would anyone
have an idea as to the type of turbo that would be suitable? If I was
to use a turbo suited to 250 HP perhaps it would cope with the
sustained hi power output? Andrew. CampBell

You could get 120 HP out of a P-port one rotor if you used a 3.12
gear box. No turbo.

Paul Lamar

True.  The one I bought dynoed at 112 HP with a 1 5/8" P-port, and low compression rotor in anticipation of turboing, but before installing it.  That is if I believe the plot supplied with the motor when I bought it.

Chris Cosman


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.