Anyone know if Tracy is still providing any technical support, or is he done
completely?
Jay Jacobs
Tracy is definitely providing technical support. He is retiring because
he is getting to the age where he wants to do something different with
his time.
Dave Leonard
Thanks David
I've got an interested buyer for my 20B but he wants to see it run first.
Several years ago I couldn’t get it to start. Turns out the EC had not
been
properly programmed.
By the time I got the repaired EC back from Tracy my project had been set
aside. Only now I still can't get the engine to start.
Jay Jacobs
Put a long screw driver next to your ear and touch the injectors
one by one. You should hear a click when the injector operates.
I assume you have spark.
Take the lower plugs out and put a table spoon of auto TX oil in each rotor.
If you have a compressor.. Find a 3/4 or one inch drive socket that fits
the large nut on the front of the e-shaft.
Use a large air wrench to turn the engine over at high speed .
No compressor use two
12 volt batteries in series to turn the engine over at high speed with
the starter
running on 24 volts. Only do this for a few seconds. Then stop and let the
starter cool.
Get some either starting fluid. Spray that into the intake.
If the timing is set correctly it should fire a couple of times.
If not you have a mixture problem.
If you have the exhaust off check the apex seals for in an out motion
with a screw driver.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.