Subject: for sale 20B Tracy EFI won't start
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 2/13/2015, 12:24 PM
To: AA-1-Me



Anyone know if Tracy is still providing any technical support, or is he done
completely?

Jay Jacobs



Tracy is definitely providing technical support.  He is retiring because
he is getting to the age where he wants to do something different with
his time.

Dave Leonard

Thanks David

I've got an interested buyer for my 20B but he wants to see it run first.
Several years ago I couldn’t get it to start.  Turns out the EC had not
been
properly programmed.
By the time I got the repaired EC back from Tracy my project had been set
aside. Only now I still can't get the engine to start.

Jay Jacobs


Put a long screw driver next to your ear and touch the injectors
one by one. You should hear a click when the injector operates.

I assume you have spark.


Take the lower plugs out and put a table spoon of auto TX oil in each rotor.

If you have a compressor.. Find a 3/4 or one inch drive socket that fits
the large nut  on the front of the e-shaft.
Use a large air wrench to turn the engine over at high speed .

No compressor  use two
12 volt batteries in series to turn the engine over at high speed with
the starter
running on 24 volts. Only do this for a few seconds. Then stop and let the
starter cool.

Get some either starting fluid. Spray that into the intake.
If the timing is set correctly it should fire a couple of times.
If not you have a mixture problem.

If you have the exhaust off check the apex seals for in an out motion
with a screw driver.


Paul Lamar


With the Fuel OFF, there is a setting of the EC-2 (and presumably the EC-3)
where pushing the  button will cause continuous firing of the injectors. I
am away from my manuals right now but I believe that it is setting 1 on the
mode button. There is also one setting the will fire the plugs.

Best if fuel is off, otherwise you will flood the engine.
Bill Schertz


Yes Bill it's mode 8 and mode 0.  Both injectors and plugs are firing on the
B side of the EC. Nether of them test fire on the A side.

I tried Paul's air gun suggestion but apparently 150 psi isn't enough to
turn over the engine.

Jay


What size is the square plug on the air gun, 3/4 or 1 inch? (for future reference)
The larger the plug the stronger the air wrench.

My 3/4 puts out 500 foot pounds at 4500 RPM with 90 psi. Harbor Freight special.

That ought to do it :)


Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.