Subject: Fwd: Re: Private - Sun 'n Fun Fly-In
From: paul
Date: 2/22/2015, 6:55 AM
To: AAA-rotaryengine


good luck :) Your dealing with a bunch of creative control freq s  here.

Also much is determined by what they can buy.
These engines are basically the same since 1973
except for porting. There are at least a dozen different
porting configurations.

Over 2.5 million have been sold


Would it be wrong to suggest that a certain build be standardized !  I mean if a certain Mazda Engine Model being equal (example13b engine model), and a non-turbo charged, sort of a starting design ?  once done move on to variations each year, a one rotor build in 2017, then 2018 a turbo charged three rotor ???

On Sun, Feb 22, 2015 at 4:44 AM, paul <rotaryeng@earthlink.net> wrote:
So far no two are identical

what you see on on here are suggestions

people have their own ideas


On 02/21/2015 10:52 PM, George Curtis wrote:
That's fast, how long to assemble PSRU, Cooling, EFI, Carb, and add the engine motor mount to the airframe, wiring engine to panel perhaps would be to long for a show...

On Sun, Feb 22, 2015 at 1:47 AM, paul <rotaryeng@earthlink.net> wrote:

We used to do that in the engine tent. There could be 2 12A's still
there. I am no longer a volunteer in the engine tent but we might
be able to arrange it.

It takes less than 15 minutes to take it apart and about 30 to put
it back together not counting cleaning
Cleaning takes a week :)


On 02/21/2015 03:36 PM, George Curtis wrote:
Paul not sure if I said this before to you, but for years, I have thought that since you attend the Sun 'N Fun Airshow in Florida, it could be possible to have a Wankel Rotary Engine Build Demonstration along side of your classes.

My thought is if we could try this in April 2016, gather a few of the people manufacturing PSRU's, your EFI, Engine Motor Mounts, Cooling System, and other components, to form a team doing an engine build from scratch.  I think we could put out in EAA Sport and Kitplanes Magazines that we were looking for a person doing a home built with the airframe near completion, to the point of the engine install could apply to be the demonstration project for the week at Sun-N-Fun

After finding out the cost of renting a suitable area to work on the rotary engine build, allowing the public to view the event, schedule start before the dates of the Sun 'N Fun event so that the build is along the way far enough to show the key points of the advantage of the Rotary Engine, but finish the final build near end of Sun 'N Fun Fly-In show. The costs of parts, and having necessary components on hand to be run through weeks before the show, by the build team and aircraft owner, so that no surprises happen.

I think you could get several people, like my self to pay for the event as a live training seminar.  As an example, cost of display area for the week $500, hotel rooms for build team $2000, hand outs $500, so $3000 total with 15 people paying $200 each, its covered. I know I would like to run through a complete tear down and build, up to installation.  Promote the Fly-In to draw other Rotary Powered Aircraft to be shown off and viewed during the event.

Given that the tear down and build would mostly take longer than the show dates April 5 - 10, 2016 I think it can be done in 6 to 8 days if all components are in place with a team of experienced builders on hand.

I think it could go a long way to demonstrate to home builders how much you and others have moved the use of the Rotary Engine along.

I would be glad to call, schedule, make arrangements for the eventt, if you think it can be done.

Thanks George F. Curtis Jr.