Hi Paul,

I have been  reading dozens of emails about the PSRU gearbox and
looked at the your attachments.

Unfortunately I having been reading these emails, I am getting
slightly confused so I would like to start a short thread to clear
the confusion.

Would I be correct in assuming the PSRU being built by some guys on
this mailing list is derived from  ORG_ROSS_DWG2.jpg drawing ?

There are altogether 16  components in that  drawing. Would I be
correct in assuming that some of the parts are available and one can
get them if they know the manufacturers part numbers ? If my
assumption is correct what are the manufacturer part numbers
corresponding to the 16 components ?

Are they also modifications to the original drawing there fore new
components are involved ?

Thank you Zahid Rahman

Yes the entire planetary gear set is available from transmission
repair part wholesalers in the US. One is in southern California
called Slauson Transmissions Parts. Cost about $200 US.

http://www.slauson.com/  One must own a company to buy from them.

Slauson has their own parts numbers. Here is a  catalogue sheet.

Yes there are quite a few suggested modifications.

Here are some.

It is cheaper and quicker to make the housing out of thick wall
aluminium tube.

Paul Lamar in Germany

Thank you sir for your response. I would first like to eliminate the
ready made parts one can buy from slausons. Can you please tell me
which  slausons part numbers  correspond  to the 16 components in
the drawing.

Best Regards Zahid Rahman


Check the attachments again. The part numbers are circled in red.

Paul Lamar



The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.