On 1 Mar 2015 04:51, "
rotaryeng@earthlink.net
<mailto:rotaryeng@earthlink.net>" <
rotaryeng@earthlink.net
<mailto:rotaryeng@earthlink.net>> wrote:
Hi Paul,
I have been reading dozens of emails about the PSRU gearbox and
looked at the your attachments.
Unfortunately I having been reading these emails, I am getting
slightly confused so I would like to start a short thread to clear
the confusion.
Would I be correct in assuming the PSRU being built by some guys on
this mailing list is derived from ORG_ROSS_DWG2.jpg drawing ?
There are altogether 16 components in that drawing.
Would I be correct in assuming that some of the parts are available
and one can get them if they know the manufacturers part numbers ?
If my assumption is correct what are the manufacturer part numbers
corresponding to the 16 components ?
Are they also modifications to the original drawing there fore new
components are involved ?
Thank you
Zahid
Yes the entire planetary gear set is available from transmission
repair part wholesalers in the US.
One is in southern California called Slauson Transmissions Parts.
Cost about $200 US.
http://www.slauson.com/ One must own a company to buy from them.
Slauson has their own parts numbers. Here is a catalogue sheet.
Yes there are quite a few suggested modifications.
Here are some.
It is cheaper and quicker to make the housing out of thick wall
aluminium tube.
Paul Lamar in Germany
Now that I have Ford components some things are beginning to make
sense.
Just to confirm the picture of Ford arms length are the slausons
parts put together to make component 8 of Ross's drawing.
Zahid Rahman
Yes. Hold off on the email for a few days. It is hard to find good
email service in germany.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.