Hi Paul,

    I have been  reading dozens of emails about the PSRU gearbox and looked at the your attachments.

    Unfortunately I having been reading these emails, I am getting slightly confused so I would like to start a short thread to clear the confusion.

    Would I be correct in assuming the PSRU being built by some guys on this mailing list is derived from  ORG_ROSS_DWG2.jpg drawing ?

    There are altogether 16  components in that  drawing.
    Would I be correct in assuming that some of the parts are available and one can get them if they know the manufacturers part numbers ?
    If my assumption is correct what are the manufacturer part numbers corresponding to the 16 components ?

    Are they also modifications to the original drawing there fore new components are involved ?

    Thank you
    Zahid

    Yes the entire planetary gear set is available from transmission repair part wholesalers in the US.
    One is in southern California called Slauson Transmissions Parts. Cost about $200 US.

    http://www.slauson.com/  One must own a company to buy from them.

    Slauson has their own parts numbers. Here is a  catalogue sheet.

    Yes there are quite a few suggested modifications.

    Here are some.

    It is cheaper and quicker to make the housing out of thick wall aluminium tube.

    Paul Lamar in Germany

    Hi,

    I can't find any information on the Torque meter piston  and Torque meter cylinder shown on the Input-Shaft5.dims.JPG
     Where do these parts come from and what do they look like.
    Best Regards
    Zahid

    You have to make them.

    Paul Lamar back in the USA


    The Rotary Engine News Letter. Powered by Linux.
    ACRE NL web site. http://www.rotaryeng.net
    You Tube http://tinyurl.com/beqqxas
    Copyright 1998-2015 All world wide rights reserved.