Subject: Gear box adapter plate and front motor mounts.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 3/29/2015, 8:19 PM
To: AA-1-Me



It is kind of hard to get this made over seas in aluminium
and the cost of shipping from the US is quite high.

The density of aluminium is .1 pound per cubic inch.
The density of birch plywood wood is 42 pounds
per cubic foot or .024 pounds per cubic inch.

If you laminate thin stainless steel or even galvanised
steel ducting material to both sides a  1/2 inch thick or
12 mm thick plywood you will get a very strong and stiff part. The part
will be heaver than the NC milled
version but not that much heavier.

Two square feet of plywood would weigh 144 cubic
inches times .024 pounds or 3.5 pounds. Add 2 pounds
for the steel parts and you get about 5.5 pounds. Not
that bad. I will weigh the NC milled aluminium
plate tomorrow. My guess is it will be with in a
pound or so of the NC milled aluminium plate.

Also plenty strong enough to do the job.
Use epoxy which has a bond strength of 3000
pounds per square inch.

Paul Lamar

----------------------------------------------------
I weighed the NC milled plate. About 4 pounds.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.