Hi Paul,

Still a bit stuck with  implementing torque meter.

When I search for drive shaft torque meters I have found ones like
on this website
http://contact.binsfeld.com/torquetrak/?gclid=CM_7mOzc0sQCFU_MtAod4yYA5A



Zahid Rahman

We are not measuring the torque on the input shaft directly.

We are measuring the reaction of the helical gear to applied torque.

I sent this before so make a folder called torque meter and copy
them to that folder.


Paul Lamar


Zahid,
You can also install it under the loaded side mount where the engine torque
will press down on it.
You can use a small hydraulic ram like from a porta-power or make your own.
Just needs a hole in the center for the bolt. Zero the pressure gauge with
just the engine weight on it. Another way is a piezo load sensor.

Dale Davies

Here are a few pictures of what you are talking about Dale.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.