Subject: JEAN SPEED REDUCTION GEAR BOX PROGRESS
From: paul
Date: 4/8/2015, 9:09 PM
To: AAA-rotaryengine



Paul
Is coming almost to the end, the fact the business slowdown I can work again on my project.
I just finish the shaft splines and I made it tight fit and need the light pressure on hydraulic press, the center shaft is drilled for a constant speed prop and the side holes are not done yet, I still make the end treads on the shaft to fit for holding nut.
A bearing will be fit on the hub prop flange pressure fit with a retaining ring for trust and also a bearing in the back on the planet gear hub ,on the middle casting I did machine a brass bushing with groove and holes for the prop oil passageway.
The front casting hole it will  be use to install set screw as double trust holding on the front seal bearing the back holes some will be plugged and weld
I send you photos of the progress ,I will try to complete and  bring it to Sun&Fun if I can
.
See you there Paul



JEAN PRUDHOMME


Looking good Jean.
What does it weigh?

I might not make it to sun n fun this year.
The final draft of my patent is due about that time..

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.