Paul could you tell me how many screw and size Tracy use to hold the
planet outside gear, I am set up on the milling machine ready to make
hole and taps. Thanks
JEAN PRUDHOMME
Tracy used eight 1/4 flat heads with the stock Ford powdered metal
bulk head. They sheared off clean on Mark Steitle's 3 rotor.
I don't recommend doing it that way. The powered metal Ford bulkhead
is too hard and too brittle.
Use a bunch of extended point set screws in from the outer housing.
BTW Industrial Metal Supply in Burbank CA has thick wall aluminium
tube for PSRU housings. Great outfit! Been doing biz with them for 50
years.
www.industrialmetalsupply.com/
Paul Lamar
The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Store
http://www.rotarpower.com/#! Copyright 1998-2015 All world wide
rights reserved.
Paul,
Stock bolts are 1/4-28. I re drilled them for 5/16. Failure was caused
by rough
running engine due to tuning issues related to the EC-2.
Mark Steitle
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Store
http://www.rotarpower.com/#!
Copyright 1998-2015 All world wide rights reserved.