This is Mike Will's RV4. Mike did an amazing job of packaging a rotary
with cooling in an RV4 without the cylinder cheeks. Getting all of it in
the cowl was not easy. Mike used a wedge shaped Kays & London
diffuser. It cools on the ground and in the air well with about 30 hours
on the installation.
One of things Mike had to do was build a special
trick oil pan. The pan extends back behind the engine about
4 inches. Mike used a back top plated bolted on with a zillion
tiny screws. It is a nightmare to get it off and back on without
leaks. Surprising it holds about 4.5 quarts. I want to weld a fitting
on the front end for Tracy PSRU oil drain back.
If I had to do it over I would use long aluminium tubes through the
pan and use long studs made from metric 8MM 1.25 pitch threaded rod.
McMaster Carr sells it.
Here are picture before I moved the oil filter and several after I moved
the oil filter to make room for the Lamar Instruments Inc. coils. The
coils are
represented by the rectangular steel tubes. Three mounted behind the right
motor mount and one ahead of it.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Store
http://www.rotarpower.com/#!
Copyright 1998-2015 All world wide rights reserved.