Subject: NEEDLE BEARINGS ON 2.250 OD 4130 TUBING.
From: paul
Date: 5/19/2015, 10:45 PM
To: AAA-rotaryengine



Paul



  I did machined the 2.250 od by .250" thickness 4130 tubing and the prop flange with 45mm hub been press fit with .005" oversize.


Like you show on your sketch I will drill and tap for 15 of 10/32 ' dia x 2" long high tensile screw as http://www.mcmaster.com/#92610a533/=x96d8l

The 15th drill hole will be for a .250 " dia sheer pin acting as keyway  for alignment  of both parts at the assembly on hydraulic press.
I found only one needle bearings who can fit with the 2.250"dia tubing as  SJ8407  and weight  a pound each plus 1.750 long.

The only option with 60mm bore needle bearings are lighter  but by using a 2.375" OD tubing it does not give any gain in weight but it increase a bit more.

An other question you know the planet housing is made with powder steel and I never weld  steel to this kind of material.

I have to weld those part together with the tubing wall of 3/16" thick after machining to suit the planet hub plus shear pins
There is some photos



JEAN PRUDHOMME

We don't weld on the planet carrier.
We bolt it to a 4130 flange welded to the prop shaft or bolted on if the
prop shaft is thick enough.

Last six pictures.


Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Store http://www.rotarpower.com/#!
Copyright 1998-2015
All world wide rights reserved.