Subject: side-draft carb for p-port slide throttle
From: paul
Date: 5/22/2015, 3:20 AM
To: AAA-rotaryengine

I have been thinking of upgrading Mike Wills RV4 to a p-port
with carburettor. I have a p-port RX8 engine in the hangar.
That is the one that ran on the dyno.

It is pretty low cost to make a two barrel side draft p-port carb from
Holley parts using the slide throttle.

Randy can machine the adapter plate that holds the
Holley float bowl to the intake tubes

The tubes can be rotated slightly to give more room
for the Holley float bowl.

Fuel injection is too hard to tune and adds to the length
of time needed to get flying. Fuel burn with EFI is not
significantly better than carbs.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Store http://www.rotarpower.com/#!
Copyright 1998-2015
All world wide rights reserved.