Subject: GB Housing picture
From: paul
Date: 5/27/2015, 12:57 AM
To: AAA-rotaryengine



Finally getting there! Much to be done yet.

  Neil.


Wow!!! that's cool Neal.

Looks like it is hogged out of solid billet.
Good thing aluminium is plentiful in Oz :)

Paul Lamar

=============================================
That is a very heavy design. My guess is close
to 50 pounds.

On the other hand it is nice in that it will accommodate
a constant speed hydraulic prop. That will
cut the fuel burn some what and shorten the take off run
but your p-port powered aircraft with your long strip
does not need it :) BTW I hope to go for a ride
in September when Robin and I come over for the OZ
Oshkosh..

The max OD on the housing is now about 6.5 inches.
If you cut that down to 5.9 inches you will save
about 3.5 pounds.

The OD of the 2.85 ring gear is about 5 inches so the
wall thickness of the gear box housing would be reduced
from the way over kill 0.75  inches thick  to a more normal
0.3 inches thick.

Since the powdered metal bulk head is now behind the planet
carrier the 1000 foot pound prop torque is not taken by
the front housing.

Then you need shorter 1/4 20 socket head machine
screw's with the nut on the inside of the PSRU adapter
plate. Currently the extra long 1/2 hex head screws
are hard to find and weigh more.

Also the big nut that takes the prop thrust could
be shorter. That will save a bit of weight as well.

More weight can be got out the aft part
of the housing.

Paul Lamar


 The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Store http://www.rotarpower.com/#!
Copyright 1998-2015
All world wide rights reserved.