Subject: Pic of Cozy IV motor mount
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 5/27/2015, 3:33 PM
To: AA-1-Me

Paul:

Attached is a pic of my COZY IV motor mount (1" O.D. 4130 tubing), Dodridge Plate, & RX-8. It all worked out well, except now I have to fabricate the front support link from oil pan center---------------- to lower center firewall. We put a scale at the front of the oil pan (removed the 4x4 support column) and measured 160 lbs of weight vertically downward.

Can you advise best way to fabricate this link? Possibly 1" O.D. 4130 tubing with 3/8" rod ends at each end---------- for thrust line adjustment? Total length needed is about 12" at 45 degrees.

Thanks and regards,


cozyflyr

Paul:

Did you get the pic of my Cozy IV engine mount?

Thanks and regards,

cozyflyr
Now I did.
 You did a good job.

It Will be less load back there with a prop and starter.

Also when the propis generating thrust the load is reduced.

A 1/2 inch diameter tube will work with a smaller rod end.

That looks like a stock RX8 oil. It would be better with a deeper oil
pan. Then weld ears on the back wall of the pan and go up to the top
of the firewall. Here are some 3D's and pictures on the subject.

Another way is a top c enter horizontal mount. Probably
the easiest as a Cozy has a lot of room above the engine.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Store http://www.rotarpower.com/#!
Copyright 1998-2015 All world wide rights reserved.