Subject: Fwd: Re: Powersports aviation engine(PRIVATE)
From: paul
Date: 5/31/2015, 7:27 AM
To: AAA-rotaryengine



Paul, I finally got my rv8 home and in the shed attached is a
picture. I was wondering on the radiator you mentioned mounting
underneath. Is there a kit available?  And the other question I had
was if anyone had ever put an electric fan on the current setup? Just
curious, anyway I'm anxious to get her running and hear how she
sounds.

Thank you, scott



I would run it up at max static RPM on a hot day for 5 minutes  and
see what the temperature does. If it does not overheat fly it in the
pattern on a hot day for a couple of go arounds.  If it does not
overheat keep it as it is. It is a lot of work to change the cooling
system.

No kit but this is the best rad to use. The tanks need to be removed
and aluminium tanks welded on converting it to a 2 pass design.

Do you have my book How to Cool Your Wankel? It is a good idea to get
the book. You can now buy it with a credit card from the store
below.

People have used electric fans but it does not help much as it take a
lot of air flow to cool the engine.

Paul Lamar


Hey Paul,

Do I understand you to be telling him to set up a two pass system where
the water flows one way through half the core, then the other way
through the other half of the core, with the inlet and outlet on the
same end of the core?

That configuration is less efficient than using the same core in a
single pass configuration.  The coolant must flow at twice the velocity,
which it will not due to increased flow resistance at the higher
velocity, to achieve the same cooling efficiency as the same core in a
single pass configuration.  The second pass will have a lower delta T
between the cooling air and the water than the first pass.  Half the
cooling air that the air plane sucks in will not be doing much to cool
the engine.  That configuration will result in a higher than necessary
mass flow rate and thus increase the cooling drag.

The resultant lower coolant flow rate through the engine will also
reduce the cooling efficiency by reducing the turbulence inside the
engine cooling jacket that helps transfer heat from the metal to the
coolant.

If you are talking counter flow, where the hot water flows through the
downstream core first, then through the upstream core last, in relation
to the cooling air flow which comes in contact with the cooler side of
the radiator first, then I agree with you.

A counter flow cooling system will result in lower cooling drag and
better fuel efficiency for the airplane.

  Mark LaPierre

You have a good understanding on this Mark.

True but the plumbing advantages out weigh the reduced efficiency
IMHO. However I don't have any real numbers on that yet.
There does not seem to be much difference as some race cars
use the 2 pass system. The diffuser shape makes a lot more
difference. One can always use a slightly larger frontal area core
to make up for it.

Yes I agree on the cross counter flow. Solves both problems but it
is very expensive to build as I have built several.

Paul Lamar.