Subject: Lower cost tapered PSRU prop shaft.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 6/18/2015, 4:58 PM
To: AA-1-Me

This is held together with a tension bolt. Not shown in the 3D.

This is the same way the three rotor is held together and the flywheel
is attached to the e-shaft on all rotaries.

No extended point set screws needed but could also be used.

No welding on the planet carrier flange like the Ross was done.

It is a seven degree taper which as I recall is a machine tool standard.


Uses roughly 2 inch diameter needle  prop shaft  bearings and thrust bearings.


Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Store http://www.rotarpower.com/#!
Copyright 1998-2015 All world wide rights reserved.