Subject: Lower cost tapered PSRU prop shaft. 2
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 6/19/2015, 10:59 AM
To: AA-1-Me



This is held together with a tension bolt. Not shown in the 3D.

This is the same way the three rotor is held together and the flywheel
is attached to the e-shaft on all rotaries.

No extended point set screws needed but could also be used.

No welding on the planet carrier flange like the Ross was done.

It is a seven degree taper which as I recall is a machine tool standard.


Uses roughly 2 inch diameter needle  prop shaft  bearings and thrust
bearings.


Paul Lamar

More pictures of the new taper prop shaft.
Still no tension bolt shown.

Paul Lamar.



The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Store http://www.rotarpower.com/#!
Copyright 1998-2015 All world wide rights reserved.