Subject: Time to climb cooling system 2
From: paul
Date: 6/27/2015, 8:05 AM
To: AAA-rotaryengine


This still may not be enough for a 650 HP rotary so some water will be needed to spray on the rads. This has been difficult to plumb. The best way to avoid plumbing night mares is get every thing under the cowl or foam mock ups of everything and then design the motor mount :-) This is one of the worst motor mounts I have run across in 16 years of the newsletter. Dan Gray did not do it. The person who did will go unnamed.

Paul Lamar

The poor motor mount was partially the fault of poor planning.
Little thought was given as to how the engine was installed
in the aircraft.


This part was designed to adapt the gear box to the rotary.
The same as Tracy original adapter plate. It was a golden
opportunity to provide motor mount hard points suitable
for use in an aircraft. This point was missed in its design.

The engine was rotated 15 degrees clockwise looking from the
front in an attempt to get the turbo in the frontal area
of the Harmon Rocket. It did no work but it was better
than perfectly upright. Cooling oil drain drain back
from the rotors is critical and that works best when
the engine is upright.

If the tilt  had been known when
this adapter plate was designed hard points for the
motor mounts could have been added greatly simplifying
the motor mount.

We did this way back in 2000 as I recall  with
the KIS cruiser motor mount. Crash tested later by Bob White
in his BD4 :-)

If the ex-project engineer
had been on the newsletter as late as 2013 when this project
was started the ex-project engineer would have known this.

In any event it was also possible to redesign this part after
the tilt was chosen. As I said before the motor mount
should be the last part designed when installing
a rotary in any aircraft.


Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Store http://www.rotarpower.com/#!
Copyright 1998-2015 All world wide rights reserved.