Extended point set screw way of coupling the sun gear to the silicon
rubber coupling.
This is retrofit able to most of Tracy's gear boxes.
It is much stronger and eliminates most of the back lash.
No spline. The input shaft is increased in diameter from one inch
to an inch and a half.
Ten 5/16th set screws are shown but I think we could go up to 3/8th set
screws
which are much stronger.
The silicon rubber coupling will be used in the time to climb engine but
that is a straight cut sun gear without the axial helical gear thrust.
Some what simpler to implement.
The PSRU adapter combination motor mount will have to be re-bored
for a larger oil seal. The helical gear thrust will be reacted by this plate
instead of the thrust bearing in the engine which is not up to the job.
This was discovered about ten years ago.
There is room between the sun gear and the PSRU plate for a torque sensor
hydraulic cylinder such as done in the PT6 gear box. Torque is directly
related to helical gear thrust.
Paul Lamar
This is a modification of the EPSS coupler design. I found the sun gear
too hard to tap. Drilling is no problem with the right carbide drills.
Thread taping is a lot more of a problem in materials this hard.
So I used short sections 3/8" drill rod instead. There is a collar that
slips over them and holds them in place.
The black thing around the shaft is a teflon graphite high pressure seal.
Recommended for retrofit for all Tracy's gear box.
We will be testing this coupling on the 650 HP time to climb engine.
Randy, let me know if you get this as it is part of the new PSRU design.
I am having trouble with earthlink not sending out messages.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Store
http://www.rotarpower.com/#!
Copyright 1998-2015 All world wide rights reserved.