Subject: Fwd: Re: 20 B HR 2
From: paul lamar
Date: 7/19/2015, 2:26 AM
To: A10-Me-Earthlink


        An all aluminum 20B should be about 300 pounds. P-port with turbo
       should give an easy 600HP. To get a higher HP capability gear box
        I would use the Allison HT 640/HT 650 series planetary with approximately
      3.5:1 ratio. This transmission was designed for use in 5 ton trucks
       and buses. These transmissions are readily available and so are spare
        parts. Probably a lot cheaper than the helicopter PSRU. The design
       would mimic the current Ross/Tracy box with dimensions changed
        to accommodate the Allison part dimensions. The weight should be
        close to the helicopter box and the length should be similar.

        Dale Davies

        The helicopter box is surprisingly light with magnesium castings
        at only 45 pounds..

        The drawback is; it is $30,000.

        Paul Lamar


        Dale,
         Do you know which planetary of the Allison has the 3.5:1 ratio ?
        Kelly Troyer

        Allison transmissions have a number of current and obsolete
       transmission series, all designed for medium to heavy duty use.
        AT 500 series. Kind of like an overgrown turbo hydramatic 400.
        The torque converter I am told can be used on a TH 350 giving
        a low stall RPM which can help fuel economy.
       MT 640/643/650/653 series. There are more models in this series
        but these are the ones to look at. I believe they have 6 pinion
        low planetary with the 3.58:1 ratio. This is a medium duty trans
        designed for 250HP and 640LB/FT of torque. I do not think the
       HP is a concern. The torque capability is the advantage.
        HT 740/750 series. This is a more heavy duty trans as the 445HP
       and 1435LB/FT torque capacity indicate. This has a 3.69:1 first
        gear ratio.
        CLT-3461. This trans was used in the Terex 14B scraper with
        twin engines and transmissions. The engines were Detroit Diesel
        4L71 naturally aspirated. Similar in size and power capacity to the
        AT 540 but with 6 speeds and the first gear was 3.81:1. If a wide
        cord prop was used with it I think noise could be kept down.
        A search of Allison transmissions will bring up a lot of information
        with diagrams.

        Dale Davies




         Dale,
      So far in my research on the Allison MT 640/643/650/653 series the parts
    diagrams and photos I have seen of the planetary's have 4 (straight cut)
    pinions that will reduce or eliminate the load on the thrust bearing for the
    input shaft..........

    Thanks,
    Kelly Troyer

Here are some Allison pictures.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.