Subject: gear box coupling improvements
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 7/20/2015, 4:46 PM
To: A10-me-earthlink

The time to climb project gave me the opportunity do
further work on the engine coupling to the gear box.
I liked  the extended point set screw idea to fasten
the sun gear to the input shaft from the silicon rubber
coupling.  One of the problems with the initial design problems
 was the diameter of the input shaft was too large for long life
helical gear thrust bearings.

I had to go down on the diameter and put a steel shaft
inside the sun gear. The gear box side of the aluminum billet coupling
was bolted to a steel flange with flat head screws.

Another problem was the sun gear was hardened
steel and it was difficult to tap. One could drill it no problem
with good quality carbide drills but taping  seemed to be
out of the question. So I replaced the set screws with
short cylinders. They will be held in place with a slip
fit collar.

We are building a teflon mold for the silicon rubber torque
isolator bushings.

We also did a FEA animation on the set screw coupling.

The same size coupling with minor modes will be used in
the 650 HP time to climb engine. It is VERY strong.


Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.