Mounting the oil filter on the PSRU adapter
plate worked out well.
One of the many advantages of mounting the filter
on the adapter plate is you can use a device called
a "pressure gauge in line adapter" to feed engine oil pressure
to the PSRU right out of the filter.
These are quite handy.
Paul Lamar
Paul, That answers a few questions. My new engine has the very same set
up but with fuel injection. Was worried that the runners were getting
too long, but exactly the same, but I do not have the clearance on top
as this motor has. By the way how does the dip stick fit? Probably
just the angle of the photo.
Neil Unger.
The old dip stick hole was plugged and the oil filler tube was removed.
The oil filler tube hole was converted to a oil system breather.
It is usually quite easy to add a dip stick to the back of the oil pan.
In this case Mike Wills built the oil pan with a rearward extension of
about
6 inches. He did this as the pan was wedged shape to get room
for the cooling system diffuser and he needed more volume
in the oil pan. The filler cap is shown in this picture.
You must remove the cap to check the oil level.
Mike did a masterful job of squeezing everything into
a 24 inch wide cowling.
I guess a sight gage could be made from glass tubing
and mounted on the side of the oil pan.
If i ever take the oil pan off (a really big job) I might consider that.
I need a PSRU oil drain back fitting on the front of the oil pan.
As it is now I run the PSRU oil drain line back all the way
to the rear of the oil pan.
Paul Lamar
I came up with a better idea on the oil feed to the gear box.
I had trouble finding a male dash 8 AN "pressure gauge in line adapter"
to 1/2 inch NPT. Apparently nobody makes that animal yet.
They make dash 8 to 3/8 NPT but then you have to use a reducer.
They make dash 8 female versions but then you have to use a straight
1/2" NPT to male dash 8 out of the filter holder.
It gets kind of mickey mouse and long as you can see from this first
try picture.
Turns out there is a place in the centre of the oil filter holder
fortunately that
communicates with the out put side if you drill and tap for
an 1/8 inch NPT. Much neater as you can see from the second picture.
There is a vast variety of AN fittings that it is kind of hard to sort
it all out
sometimes.
Paul Lamar
I had a similar problem years ago. Install a fuel filter for a stand-by
4L71 Detroit Diesel power generator. The filter had ORB connections.
I went to Aeroquip and was told they did not have the direct fitting
required in the hose size already installed. He came back with a
bunch of fittings screwed together about a foot long. While he was
getting that monster together
I looked in the clearance bin to kill
time.I took two of the ORB fittings he had and grabbed two
clearance fittings with the correct SAE end. Back at the shop I
cut the SAE taper ends off all fittings then silver soldered the needed
ends onto the ORB parts.
Problem solved and it looked like
manufactured fittings. The Aeroquip counter clown thought I was an
idiot. Well, life experience has shown me that the the feeling is
usually mutual!
Dale Davies
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.