Paul, would using a CO2 bottle and spray bar be effective in cooling
the time to climb heat exchangers?
Ray Hellstrom
I never tried that. I assume it works better than a cold water
spray. We have a ten gallon tank and a 100 psi pump for intake water
injection and we planned to also use that for spraying cooling water
on the cross counter flow heat exchanger.
How much CO2 would we need for one minute and how much would it
weigh? The pressure tank sounds heavy.
Paul Lamar
Paul, I'm not sure how long it would run as I not up on the
calculations for the delta temperature would be but I see a five
pound capacity bottle weights eight pounds. There are 2.5 pound tanks
but again not knowing the amount needed I couldn't advise on it. CO2
is cheap and safe unless punctured.
Ray Hellstrom
I'll stop with this link from the company web site:
http://www.designengineering.com//content/cryo2-cool-way-get-more-power
Ray Hellstrom
Water converting into vapor (latent heat of vaporization) absorbs 970
BTU per pound. CO2, 247. I think on your minute and a half time scale water
will be the right answer, but it will only be useful for the period of
time that
it's actually contacting the hot metal; any water that drips off will
not have absorbed as much heat as it could have if converted to vapor.
If you needed cooling for a few seconds CO2 might be worth the weight
penalty but you'd still have a problem getting the heat to transfer out
of the metal into the CO2 liquid.
David Josephson
Exactly what I needed David. Thanks. Our temperature red line is 185 F
on the 650 HP
time to climb engine so I don't think we will be making any steam (vapor).
Paul Lamar
It is not heat transfer to the liquid CO2. The big advantage is
releasing the pressure through a fogger system into the air
passing through the intercooler and radiator cores. That generates
a large temperature drop. This is part of the benefit of N2O
systems in that they promote a denser intake charge from
the cooling.
To test the cooling effect, put a cup of water in an ice cream
pail when you have a full 20 LB propane tank. Open the valve
so the vapour is directed to the pail. With the newer propane
hose connector the propane is blocked unless a hose is
connected. It should only take a few seconds to freeze the water.
Dale Davies
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.