I have been doing it off and on since the early 70's starting with
tape and mylar.
Is this just me? :-)
Good thing I only populated it partially and tested it with a
current limited power supply! If I had connected it to a 12 volt
car battery it would have melted the PC board and burned down the
hangar!!
Paul Lamar
I started in the late 70s with tape and mylar and was thrilled to
toss all the last cir-kit transfers in the trash about 20 years ago.
I use Cadsoft Eagle, there is a free version. You can confirm that
the board matches the schematic and none of the traces will short
out. That's enough for me. The last dozen or so layouts have worked
the first time for me.
David Josephson
Thanks for the tip David. I'll take a look. I assume you have to do a wire
list and input a schematic or can you just input integrated circuit part
numbers?
Can you send me a sample input file?
I use ExpressPCB directly. I don't enter a schematic or bill of
materials into ExpressSCH.
I have never used it.
Perhaps that is what I am doing wrong. I tried one of those programs in
the distant past and I was not happy with the part layout. There is
sometimes
more to the part layout than just all the proper connections.
Is there a free schematic editor with Cadsoft?
The thing about ExpressPCB is the boards are cheap and the service
is pretty fast. They do charge for UPS 2nd day shipping when parcel post
would be as fast and cost way less. Submitting your design is fast and
easy as they have a web site that accepts your design file directly
in mere seconds.
The downside to doing it my way is once you submit the design
you pay for the possibly defective boards no matter what :-(
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.