Subject: Oil Filter and fuel plumbing on the 650HP time to climb engine
From: paul lamar
Date: 8/4/2015, 6:33 AM
To: A10-Me-Earthlink



It is kind of strange for Mazda to have the oil pump on the front of the engine and feed the oil into the back of the engine. This started in 1968 and is the same to this date. It complicates the external oil filter plumbing. Jim Medere modified this system so oil is fed in at the back AND the front of the TTC engine.

Paul Lamar


Hi paul,
I am sure you will have thought of it, but would using antifreeze in the total loss water to cool the time to climb engine and dropping the water temp to just above its freezing level give you a worthwhile cooling gain?

Andrew Campbell



We have been told by Jim Medere our warranty is void if we let it get above 180F :-) He also told us not to use total loss. We considered it.  That was our first  guess because it would not need that much cold water.

Paul Lamar

By total loss I was referring to a tank of water that could be sprayed over the heat exchanger to increase heat transfer, this would be in addition to the air cooling system. There would be a disadvantage in the weight factor of the tank, but would this be negated by the extra cooling and possible increase in HP that could be produced?

As I understand we are only looking for a short cooling period, The rate of heat transfer through copper is far higher than aluminium, heat exchangers used to be made from copper: Again there is a trade off with the weight of copper heat exchangers. Depending on the grades, copper is about 3 times the SG of aluminium. Given the fairly low overall weight of the heat exchanger would copper be an option?

Does anybody even make copper cores today?
The efficiency of an air cooled heat exchanger if we were to spray water on it, that is going to be used in part as an air water system, for a better word could be vastly improved by modifying the cooling fins pressed onto the tubes. Most heat exchangers are built to a price rather than an engineering optimum.

Andrew Campbell


Yes we are doing that. We have a mandatory 100 psi pump to pump water into the intake
manifold and some will be sprayed on the cross counter flow heat exchanger
as needed. I have not seen copper cores in years.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will remove  you. ACRE NL web site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas Copyright 1998-2015 All world wide rights reserved.