Subject: Time to Climb 650 HP silicon rubber GB coupling
From: paul lamar
Date: 8/7/2015, 8:05 PM
To: A10-Me-Earthlink


This is the same size billet coupling we use on the p-port rotary
more or less. Some details are different having to do with the
size of the Bell 47 gear box sun gear. Mainly because it fits all
Mazda rotaries :)

We are building a Teflon mould for the silicon
rubber biscuits themselves.

John Lynch, my hangar neighbour,
did the solid works dwgs and has an NC mill that will do the
Aluminium billet parts.

Paul Lamar

Paul, what silicone material
are you using for the biscuits? Have you calculated the compliance of
the coupling at the durometer of the rubber you'll use? David
David Josephson


Hardware store clear. No attempt at calculations.
We will test it for torque per degree twist but the stiffness
can be adjusted by moulding holes in the silicon rubber.

Paul Lamar

Paul,

Don’t use hardware store silicone if you’re casting it.  The stuff won’t cure properly and you don’t know what your properties will be.  Dow Corning sells two part silicone that is made for casting and is available in different durometers.  It also has higher tear strength than common stuff out of a tube.

http://www.dowcorning.com/content/publishedlit/45-1014_Processing-guide-LSR-FLSR.pdf

Steve Brazil

Thanks for the Tip Steve.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.