Subject: If the helicopter industry does not adopt this engine they have no brains.
From: paul lamar
Date: 8/9/2015, 6:29 AM
To: A10-Me-Earthlink



   I am sure that Felix Wankel and all other early adopters including
   Mazda would have had  no idea that 650 HP would be extracted out of
   a 200 pound, two rotor, Mazda engine.

   One thing has become crystal clear. Spark plug cooling is a major
   issue in high HP Wankel's. Jim Mederer has done wonders in
   addressing this issue.  However the time has come to rethink the
   cooling system to make it better.

   This is the way I would do it. Put the cold water in the centre
   housing near the spark plugs. Let it flow fore and aft and come out
   of the centre housing on the other side.

   The center housing has another job and that is scavenging the hot
   cooling oil out of both rotors.

   The easiest way to do that is run the engine plugs up and rearrange
   the oil drain backs. For an aircraft that makes a lot of sense. That
   way the hot water, hot oil and the exhaust comes out the bottom of
   the centre housing.

   The turbo can also be under the engine. Fuselages are higher than
   they are wide because sitting people are higher than they are wide.

   This concept not done yet. I have a lot more work to do when I find
   some spare time from the ignition biz.

   Thanks to Larry Childs for the excellent rotor housing 3D's.

   Paul Lamar


   BTW a Super Cub with this engine would set world records for STOL
   take off and landing.




   Paul, I was reading an article a little while ago, about putting
   quantum particles (silver or gold or copper or something) into the
   water and vastly improving the thermodynamic efficiency of it (the
   water). Something in the region of 50% if I recall correctly, it
   could be your answer to your cooling problems. If you think the idea
   has merit I'll try and find the article, I think it was in New
   Scientist mag. Chris. Hoskins

   I would be very interested in that.


   Paul Lamar


   This is not a surprise as any material with high thermal capacity
   would help to improve cooling. The problem is to keep the particles
   suspended over long periods of time, and at different temperatures.


   Gordon

   I am worried it would plug up the heat exchanger.

   On the micro level... how well does the water transfer the heat to
   the particles?

   Paul Lamar

   At the nano meter size, the particle receives and gives out heat instantaneously.  So in theory this works.  The trick is to have stable suspension, perhaps by using surfactants to make the particle surface pro water.  Thus the particle would suspend in the water like emissions similar to milk. But surfactants mostly are not stable at high temperature. So after some time the metal particles would settle to the bottom.


   Gordon

A few years ago, Detroit Diesel became aware of a coolant problem.
There are three compounds whose nomenclature seem similar. Silcone,
Silica, and Silicate (Sodium Silicate). Silicate is used as a corrosion
inhibitor. Detroit Diesel found that over time the silicate would come out
of suspension and form a sand like substance in the cooling system.
While the engine was running this stuff would be picked up in the flow
and due to it's gritty nature take out the water pump seal.
How would these tiny bits of metal work in the cooling system?

Dale Davies


   The Rotary Engine News Letter. Powered by Linux. If you want off the
   list PLEASE let me know and I will remove  you.  ACRE NL web site.
   http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2015 All world wide rights reserved.