Hi Paul, could you send over your CNC machine programs/drawings of the Rx8 water pump outlet block? I will forward it over to Randy and get him to machine me one. Build up his arsenal of machined rotary parts. Matt Boiteau: Sure will do. I designed an improved version. Somewhat simpler and a little lighter. You will need a pressure cap fitting from one of the car racing outfits. It needs to be tig welded to the top when you tig weld on the 90 degree pipe bends. It requires a lolly pop cuter to make. The amount of R&D spent on this device is gigantic. :-)

Thanks to Mark Steitle and others for all the work they did on it. It clears the P-port slide throttle. Paul Lamar


Paul: Is your new (improved and lighter) Rx8 water pump block available yet?

Thanks and regards, cozyflyr

Check with Randy Kempf Randy Kempf <naa73x@yahoo.com>
He is the official manufacturing arm.

Paul Lamar

A cool question-----
 
Where is the best place to measure the coolant temperature when using your
outlet block.
 
Thanks,
 
Rich Goldman

Arguably where the water comes out of the block.
The best place is don't measure the water temperature.
Measure the rotor housing temperature near the lower
spark plug.
 

Paul Lamar

The Rotary Engine News Letter. Powered  by Linux.
If you want off the list PLEASE let me know and I  will
remove  you.  ACRE NL web site.  http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright  1998-2015 All world wide rights  reserved.