does anyone have a 13b with a micro tech ignition sys i have one and
i have tried just about everything i can think of but iam still only
getting 5000 rpm and only if i advance the timing if i take the prop
off of course it will wind up to 9000 in a hurry the spark is good
to both rotors ive moved the timing in both directions only to vary
the rpm from 3000 to 5000 my a/f ratio i s from 12 to 13.5 down
around 10 at idle i am not sure if its the computer or the engine
any ideas
bob obrian
What is the gear box ratio?
What is the prop diameter?
what kind of porting?
Paul Lamar
Rd 1c 2.85:1
74 dia 88 pitch
standard 6 port was it so close i couldn't see it
thanks
bob OBrian
Mostly the prop is too large. Cut it down to 68" in dia.
A p-port would gain 50 HP at least depending on what your 6 port
manifold looks like. Send me a picture. I can then estimate the power.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove you. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.