Subject: 13b running at half power
From: paul lamar
Date: 8/28/2015, 7:59 AM
To: A10-Me-Earthlink



does anyone have a 13b with a micro tech ignition sys i have one and i have tried just about everything i can think of but iam still only getting 5000 rpm and only if i advance the timing if i take the prop off  of course it will wind up to 9000 in a hurry the spark is good to both rotors ive moved the timing in both directions only to vary the rpm from 3000 to 5000 my a/f ratio i s from 12 to 13.5 down around 10 at idle i am not sure if its the computer or the engine any ideas

bob obrian




What is the gear box ratio?

What is the prop diameter?

what kind of porting?

Paul Lamar


Rd 1c 2.85:1

74 dia 88 pitch

standard 6 port was it so close i couldn't see it

thanks

bob OBrian

Mostly the prop is too large. Cut it down to 68" in dia.
A p-port would gain 50 HP at least depending on what your 6 port manifold looks like. Send me a picture. I can then estimate the power.

Paul Lamar



I'm having the same problem with my naturally aspirated six port RX8 rotary in my Bush Caddy aircraft, max RPM is only 6100.  I'm using a three blade 76" magnum Ivo prop.  I removed one blade and tried it with the two blade set-up, problem even got worse, down to 5600 RPM.  Doesn't make sense to me.  Another thought I have is an exhaust restriction.
 I'm using a racing SPINTECH 2 1//2" inlet & outlet muffler. Anyone have any thoughts on this?

Thanks,
Bob Forbes

What is your gear box ratio Bob?

It is not the number of blades. The diameter is too large. The tips of the
prop are running into the transonic brick wall. Cut it down to 68" and sand
the  tip to a thin air foil section.

Here is the best muffler to use. Sounds better as well.
Works somewhat like a ramjet.

That SPINTECH will destroy it self. Inspect it internally  with a Harbor
Freight digital inspection camera after every flight. Aircraft have crashed
when an automotive muffler was used and plugged up. VERY IMPORTANT!

The coax muffler is much easier to inspect.

The intake manifold is critical.  Here are some old pictures of your manifold.
We had this discussion in the past and I am sure I recommended
longer intake runners. There should be plenty of room in a Bush Caddy
for longer runners. 18 to 20 inches is about right.



Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.