Paul here is the manifold to figure additional horse power

Bob O'brian.

That appears to be a side draft Weber 48. Is that correct?
Good carb but the runners are too short for a 7000 RPM
rotary. You need the runners about 18 to 20 inches long.
If you extend the two large tubes that will help. You might
be able to do it with two 180 degree 2 inch OD tubing
bends and still fit it under the cowl. Not perfect but it will
help.

You need to do a little die grinding to match up the  ports
better.

BTW who sells that manifold?

Paul Lamar


Paul,  Looks like  "Atkins Rotary" manifold................. Kelly Troyer

The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.