Subject: Break-through-low-cost aluminium end housing.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 9/21/2015, 1:55 PM
To: A10-me-earthlink


It occurred to me that the RX8 rotor housings have
the O-ring slots. Therefore the end housing can be
real simple. The steel wear surface is just the cheese
in the simple sandwich. It can even be chrome plated just
like the rotor housing for a super low wear and a super smooth
surface. When over haul times comes (if ever) it can
be replaced or refinished. One of the cheap ways of making
these things is chemical etching. One large O-ring seals the
steel wear surface to the aluminium end housing.

Light weight end housing are essential for 120 HP one rotor
light sport engines.

An external AN hose oil gallery further simplifies the engine.
An oil scavenge pump replaces the stock oil pump and
scavenges the rotor cooling oil drain back, front and rear
main bearing drain back. An after market combined oil
pressure and scavenge pump is used. Here is one from
Barnes.

These are ideas Jim Mederer, owner of Racing Beat, used
on the time to climb engine.

The end housing themselves can be NC machined billet.
No need of castings.


--------------------------------------------


I think we can incorporate the water pump housing in the front end housing.
A while back we cast up some stand alone water pump housing for the
stock Mazda water pump cartridges. They worked great. We can use
the stock low cost cartridge here as well. All aluminium versions
are available  for the second gen RX7 engines.

Here are some 3D's of what I have in mind and some old pictures.
A lot more work to do on the dwgs.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.