Subject: Break-through-low-cost aluminium end housing.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 9/22/2015, 10:39 AM
To: A10-me-earthlink


 It occurred to me that the RX8 rotor
 housings have
 the O-ring slots. Therefore the end housing can be
 real simple. The steel wear surface is just the cheese
 in the simple sandwich. It can even be chrome plated just
 like the rotor housing for a super low wear and a super
 smooth
 surface. When over haul times comes (if ever) it can
 be replaced or refinished. One of the cheap ways of making
 these things is chemical etching. One large O-ring seals
 the
 steel wear surface to the aluminium end housing.

 Light weight end housing are essential for 120 HP one rotor
 light sport engines.

 An external AN hose oil gallery further simplifies the
 engine.
 An oil scavenge pump replaces the stock oil pump and
 scavenges the rotor cooling oil drain back, front and rear
 main bearing drain back. An after market combined oil
 pressure and scavenge pump is used. Here is one from
 Barnes.

 These are ideas Jim Mederer, owner of Racing Beat, used
 on the time to climb engine.

 The end housing themselves can be NC machined billet.
 No need of castings.


 Paul Lamar

Two things come to mind. Is there likely to be distortion of the wear
plate due to the uneven temperature  from combustion side to intake
side? Can stainless be used to reduce heat transfer into the coolant?


Robert LeClercq

Yes on the stainless.

Paul Lamar

Hi Paul

The difference in expansion coefficient between aluminum and steel based alloys or cast iron will make bonding difficult between them for anything that lasts. One alternative approach is to deposit a hard coating at the surface. PVD or CVD offers so may coating choices for a variety of applications. The coatings can be custom tailored to meet specific requirements. The adhesion of a thin coating will localize the thermal expansion stresses and they would be less additive than in attempting to bond two relatively thick plates which will likely cause separation

Regards,

Simon Saba

Agreed but surprisingly brazed steel to aluminium works on frying pans.
In the case of the steel liner in the rotary housing there is a mechanical lock.

I have no intention of bonding or brazing anything. The side wear surface is held in place
with the 17 tension bolts.

Paul Lamar


 The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.