If you have a free Linux OS on your computer you can get free 3D
modelling software. 3D modelling lets you design your engine
installation to make sure all the parts fit under the cowl. 3D
modelling is what Boeing and Airbus use to design their air planes.
I have been using expensive Rhino software for years that runs on
Windows. It can also be used to design things like water pumps and
gear boxes.
It is a pain in the butt to take 2 notebooks with me when I travel.
One Windows and one Linux. Yes I know there are dual boot systems. I
feel they are too problematic for my use. I have been looking for
free 3D software that runs on Linux.
I would like to do away with Windows as it is too costly to maintain.
If your computer mother board or hard disk fails you have to buy a
new $100 windows OS from Microsoft to install it on the new mother
board. Linux OS is free.
The best thing I have come up so far is Linux Blender. The trick is
to put it in edit mode and then choose quad view under the view
menu. It then works like Rhino with 3 views, on the screen in four
windows. Top, front, right and perspective.
IMHO this is the easiest and quickest way to learn 3D software. You
draw your device in the old 2D way. Front, top and side views. It
then automatically appears in the perspective window.
I have a friend that teaches Rhino and Solid Works in college. His
students start having fun in Rhino in five minutes with Rhino. In
Solid Works it takes weeks.
More on Blender as I learn it.
https://www.blender.org/manual/modeling/meshes/introduction.html
Paul Lamar
I have blender too.
For Windows program. Just install your legal copy of Microsoft into
VirtualBox and run from inside Linux. If your computer dues, reuse it
on another machine.
Henry
I was about to tell you the same thing, Paul. By running Windows in
a virtual machine on top of Linux, you make it so Windows doesn’t
care about the hardware underneath. From the outside, in Linux, you
see a single file that contains your Windows virtual machine and its
entire file system, so you can make multiple copies of that file and
keep one on a flash drive if you want. You’ll never have to reinstall
Windows again, and the time you spend maintaining it goes to nearly
zero.
If your laptop dies, you just get another laptop and reinstall Linux
on it, and Windows has no idea you switched machines.
I used to keep a half-dozen Windows machines around for various
purposes. I converted all of them to virtual machines and I keep
them all on my Mac.
When I run something Windows-specific, like SolidWorks, I just bring
up Windows, in a window or full screen, and run it, and shut it down
when I’m finished.
A lot of people put out various programs pre-installed in virtual
machines that you can just bring up without installing anything. Once
you try it, you’ll never go back.
Dave Klingler
Thanks Henry and Dave
Paul Lamar
Hi!: thanks for the info. I do have this FreeCAD soft:
www.*freecad*web.org/ that works in Windows, but as I
don't have the expertise for drawing, I can't discuss about
its performance. Would you please tell us how this FreeCAD
software compares to others?.
Thanks, have a nice season, best regards, + salut
Jose Gros-Aymerich
Madrid, Spain
I for one have never used it. IMHO Rhino is the greatest
creative software ever :-)
Paul Lamar
The Rotary Engine News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove you. ACRE NL web site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.