Subject: Exhaust flange drawing, Renesis
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 11/5/2015, 10:24 AM
To: A10-me-earthlink



Paul, do you have any Rhino drawings of the Renesis exhaust flange.

Is it practical to make a 'hatch type' exhaust flange for the Renesis, http://www.rotaryeng.net/exhaust-joint-3D.jpg in order to avoid welding the primaries to the flange and any potential cracking at these welds.

I’m considering cutting preformed tubing bends and joining most pipes with slip joints from burns stainless, rather than direct welds for better flexibility, considering the length of the coax muffler.

http://www.burnsstainless.com/dsa-2.aspx

Alex Molteno


Yes a Hatch type flange would be good.

I think Mazdatrix sells RX8 exhaust flanges.
Here is a picture.

I don't have a dwg yet.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.