Paul, do you have any Rhino drawings of the Renesis exhaust flange.
Is it practical to make a 'hatch type' exhaust flange for the Renesis,
http://www.rotaryeng.net/exhaust-joint-3D.jpg in order to avoid welding the
primaries to the flange and any potential cracking at these welds.
I’m considering cutting preformed tubing bends and joining most pipes with
slip joints from burns stainless, rather than direct welds for better
flexibility, considering the length of the coax muffler.
http://www.burnsstainless.com/dsa-2.aspx
Alex Molteno
Yes a Hatch type flange would be good.
I think Mazdatrix sells RX8 exhaust flanges.
Here is a picture.
I don't have a dwg yet.
Paul Lamar
Paul, thanks,
I already have the flange in your photo from racing beat. There's a machine
shop down the road that can scan the flange into CAD for a small fee.
I am thinking to waterjet cut a new flange with more thickness on the sides
of the exhaust outlets and to stud the flange on each outlet with 4 studs,
to accept the outer square flange that holds the pipe. But that's going to
be a heavy solution.
Can I safely drill and tap the irons on a renesis instead to have smaller
flanges and less weight?
I assume Bill Jepson's flange in your photo has those slots cut for
vibration relief? I will include those too
What diameter material is sufficient for the square flanges, i.e how thick
should they be in order to hold the bead on the tube.
I will do the primary tubes in 321 0.065" stainless, probably the flange in
stainless too. I know the price will make my eyes water, but I don't want
it to fail on me sometime down the road,
Alex Molteno
I don't know about the renesis. You would be on the bleeding edge :)
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.