Subject: Exhaust flange drawing, Renesis
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 11/6/2015, 9:30 AM
To: A10-me-earthlink



 Paul, do you have any Rhino drawings of the Renesis exhaust flange.

 Is it practical to make a 'hatch type' exhaust flange for the Renesis,
 http://www.rotaryeng.net/exhaust-joint-3D.jpg in order to avoid welding the
 primaries to the flange and any potential cracking at these welds.

 I’m considering cutting preformed tubing bends and joining most pipes with
 slip joints from burns stainless, rather than direct welds for better
 flexibility, considering the length of the coax muffler.

 http://www.burnsstainless.com/dsa-2.aspx

 Alex Molteno


 Yes a Hatch type flange would be good.

 I think Mazdatrix sells RX8 exhaust flanges.
 Here is a picture.

 I don't have a dwg yet.

 Paul Lamar



 Paul, thanks,

 I already have the flange in your photo from racing beat. There's a machine
 shop down the road that can scan the flange into CAD for a small fee.

 I am thinking to waterjet cut a new flange with more thickness on the sides
 of the exhaust outlets and to stud the flange on each outlet with 4 studs,
 to accept the outer square flange that holds the pipe. But that's going to
 be a  heavy solution.

 Can I safely drill and tap the irons on a renesis instead to have smaller
 flanges and less weight?

 I assume Bill Jepson's flange in your photo has those slots cut for
 vibration relief? I will include those too

 What diameter material is sufficient for the square flanges, i.e how thick
 should they be in order to hold the bead on the tube.

 I will do the primary tubes in 321 0.065" stainless, probably the flange in
 stainless too. I know the price will make my eyes water, but I don't want
 it to fail on me sometime down the road,

 Alex Molteno


 I don't know about the renesis. You would be on the bleeding edge :)


 Paul Lamar

Alex. The cuts are for vibration relief and spring tension. It would be best if doing those to have them water jet cut. That way they don't ADD stress to the flange.

Bill Jepson

Have you tested those Bill?

I don't think I would try that with a turbo.

Also on a stock  RX8 engine the the exhaust port is in the cast iron
end housings. Differential heat expansion is less of a problem.

Paul Lamar

 The Rotary Engine News Letter. Powered by Linux.
 If you want off the list PLEASE let me know and I will
 remove  you.  ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2015 All world wide rights reserved.