Subject: Exhaust flange drawing, Renesis
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 11/6/2015, 4:24 PM
To: A10-me-earthlink


Paul, do you have any Rhino drawings of the Renesis exhaust flange.

Is it practical to make a 'hatch type' exhaust flange for the Renesis,
http://www.rotaryeng.net/exhaust-joint-3D.jpg in order to avoid welding the
primaries to the flange and any potential cracking at these welds.

I’m considering cutting preformed tubing bends and joining most pipes with
slip joints from burns stainless, rather than direct welds for better
flexibility, considering the length of the coax muffler.

http://www.burnsstainless.com/dsa-2.aspx

Alex Molteno


Yes a Hatch type flange would be good.

I think Mazdatrix sells RX8 exhaust flanges.
Here is a picture.

I don't have a dwg yet.

Paul Lamar



Paul, thanks,

I already have the flange in your photo from racing beat. There's a machine
shop down the road that can scan the flange into CAD for a small fee.

I am thinking to waterjet cut a new flange with more thickness on the sides
of the exhaust outlets and to stud the flange on each outlet with 4 studs,
to accept the outer square flange that holds the pipe. But that's going to
be a  heavy solution.

Can I safely drill and tap the irons on a renesis instead to have smaller
flanges and less weight?

I assume Bill Jepson's flange in your photo has those slots cut for
vibration relief? I will include those too

What diameter material is sufficient for the square flanges, i.e how thick
should they be in order to hold the bead on the tube.

I will do the primary tubes in 321 0.065" stainless, probably the flange in
stainless too. I know the price will make my eyes water, but I don't want
it to fail on me sometime down the road,

Alex Molteno


I don't know about the renesis. You would be on the bleeding edge :)


Paul Lamar

   Alex. The cuts are for vibration relief and spring tension. It would be best if doing those to have them water jet cut. That way they don't ADD stress to the flange.

   Bill Jepson

   Have you tested those Bill?

   I don't think I would try that with a turbo.

   Also on a stock  RX8 engine the the exhaust port is in the cast iron
   end housings. Differential heat expansion is less of a problem.

   Paul Lamar


Thanks Bill, I will waterjet cut if I decide to build the bolt on flanges like you have.

The bleeding edge sounds like it could be painful if it doesn't work out so I'm not going to drill and tap the irons :-)

I saw the welder today and we think this is the plan, racing beat sells this stainless flange,

http://www.racingbeat.com/RX8/Exhaust-Flanges/16168.html

We want to clearance the flange slightly so the pipes slide inside the RB flange and can be welded on the inside with stainless welding rod as per Paul's drawing, then weld the pipes on the outside with silicone bronze welding rod as its flexible and not as susceptible to cracks,

The thickest wall 321 pipes I can find at Burns are 0.065". I don't mind the extra weight on the plane of thickwall stainless tubing for the exhaust, if it lasts,

Alex Molteno



The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.