This email is to address Scott Gettings wanting to know if anyone else has a
set-up like his Renesis 6 port. I have the same set-up as Scott, and I'm
using only the four yellow injectors and have the two red ones blocked off,
as per Tracy's direction.
However Scott, I cannot get over 5900 rpm. The
engine rpm does not increase after half throttle. I checked to make sure
the throttle body was opening all the way, and it is. I also removed my
muffler and replace it with a straight pipe thinking there might be an
restriction, not the case, made no difference in rpm. I chopped my three
blade 76" prop down to 68" and still no change in rpm. I'm also using part
of the original six port intake, with no runner length. Now the only thing
I can think of is the engine cannot get enough air. Looks like I have no
choice but to completely redo my intake or try installing a super charger to
force more air in. Not sure if that will work or not. I'm using Tracy's
EC3, EM2, & 2.87 PSRU.
Bob Forbes
The intake configuration and pipe length are critical for the
HP.
The prop runs into a brick wall when the tips get close
to Mach One. What is your gear box ratio? Sounds like
2.2:1. A 3.12:1 would work better with the rotary.
When the prop torque requirements meets the torque out
of the gear box the prop and engine of course will stop increasing in RPM.
You can move peak torque around with intake pipe length.
You need roughly 18 to 20 inches of intake pipe length.
The longer the pipe length the lower the torque peak RPM.
A p-port engine will increase the max torque at any pipe lenght.
So too will NOS :-) This is probably the cheapest and quickest.
Makes up for a lot of intake configuration errors :-)
A turbo charger is more economical than a super charger
as it uses the otherwise waste energy in the exhaust to
super charge the engine.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove you. ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.