Subject: Flow Drilling - Friction Drilling - Form Drilling!
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 11/7/2015, 4:54 PM
To: A10-me-earthlink



   Hey Paul, check this out, it's pretty cool.

            Chris. Hoskins

   https://youtu.be/VzCBQh8B_RY

   I would say pretty hot ;-)

   Paul Lamar


   Oh VERY good ha ha ha

   Chris Hoskins

It is a part of how Ford builds the new Aluminum F150 bodies.
Slightly different though in that the sheet metal is not perforated.
The process puts a dimple in the sheet and swelled on the back
side almost like a rivet but it is a sheet metal screw. With the metal
not perforated, water does not get there to start corrosion.

What
would a new Shelby GT350 be like with an all Aluminum body.
You could hydroform an Aluminum roll cage welded and bonded
into the structure as part of the safety systems and save 400 to
500 pounds off the car weight. It is already a potent track car
that you can drive to the movies on Friday night. Lighter by that
much and it would be like being fired out of a cannon


What if Ford built a larger rotary with 20mm eccentricity, 140mm
radius and 70mm rotor width you would have 2037cc displacement
as Mazda calculates it or 4.073L for racing or real. With Aluminum
end housings with detonation gun applied Cermet coating, TiAl or
BeAl rotors and power recovery you could take another 100 pounds
off the front of the car.

You should be able to have a 12,000RPM
red line and 580 to 650HP in naturally aspirated form. Take that to
LeMans and run against the Camaro's and Ferrari's in the GT class.
Make the power recovery turbine housing out of TiAl or Inconel
to save weight.

Dale Davies


The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.