Subject: Gear box progress and P-port
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 11/7/2015, 4:54 PM
To: A10-me-earthlink


Hey Paul, check this out, it's pretty cool.

         Chris. Hoskins

https://youtu.be/VzCBQh8B_RY

I would say pretty hot ;-)

Paul Lamar


Oh VERY good ha ha ha

Chris Hoskins


Hi Paul,
   I am getting on OK with my gearbox, making
the prop shaft at the moment. When that is done I
can measure it up for the housing. Chris Wade is
going to 3D print out the pattern for the casting.

I am making it to fit the standard auto tranny bell
housing, I like the idea of the starter pointing the
other way (better for CG, and no blister in the cowl).

When that is done I will be doing the PP. I see the
dimension for that is 8.60" up from the sump flange,
is this correct ? Is there any need to give the hole
an angle like that Le Mans quad rotor shown, or
will "straight in" be OK.


   Cheers Chris Hoskins NZ.



Chris Wade is a good resource down there in NZ.

Straight in p-port is better as the air has less of an angle to get
into the engine. The Le man p-port engine was straight in.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
If you want off the list PLEASE let me know and I will
remove  you.  ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved.