I'm assuming that larger pinion up against the ring gear is attached to the starter. Where can we get that setup?! Adaptor plate to fit that between rear iron and bell housing? I bet that cures any flooding hard & starting issues. Spinning the engine up a lot faster than factory setup! Dan Gorsline Good question. I don't know. It does not look like a Mazda 3rd gen auto tx or RX8 auto tx starter. Most likely an auto tx starter from a larger engine. Maybe Chevy or Ford. Paul Lamar

Very interesting. Didn't know the Rx8 starter bolted to the side...
Makes it much easier to fab up a large pinion starter set-up.

Dan Gorsline.

Only on the auto TX versions.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux. If you want off the
list PLEASE let me know and I will remove  you.  ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2015 All world wide rights reserved